If the legs are ordered together with a module, there will
be 4 holes in each corner of the module bottom to fit the
legs.
Use 16 pcs. 4.2 x 13.5 mm.
FITTING
4 x Legs
16 x 4.2 x 13.5 mm
16 x Countersunk
screw Ø4,0 - 15 mm
for retrofitting
Drilling template
1. Determine position
If the module is placed up against a wall, it can be an
advantage to move the rear legs a bit inwards under the
module. Then the module can be placed quite close to
the wall, while the legs and skirting board do not touch
each other.
3. Fastening of the legs
The legs are fastened by using the enclosed screws ø4
x 15 mm. Be aware not to strip the screws. Always use
a manual screwdriver for the final re-tightening of the
screws.
4. Adjustment
The module is levelled by using the adjusting screws in
the legs.
NOTE:
Units from width 69,6 cm and upwards with legs should be fitted with support rail under the bottom.
2. Marking up
If the legs are ordered for retrofitting, please use the en-
closed pattern to determine the position of the legs.
RETROFIT
Manual / EN
CONTENT
