Blitzer Assembly Manual
Page 15 of 21
Photo 47
Photo 48
63) Mount the air scoop sides at a slight angle as shown by the
front section A-A on the plans, and as seen in Photo 47.
Widen the hole in the chin block until it is smooth against
the sides.
64) Use a piece of scrap 1/16” sheet from the kit to make a
bottom cover for the air scoop. Glue it in place, then sand it
to fit. Round the edges.
65) Using a long bolt (or by mounting the motor), attach the
spinner plate to the front of the fuselage.
66) Sand everything smooth as shown in Photo 48 in preparation
for application of filling putty
