10
LIGHTING INSTRUCTIONS
If any burner fails to ignite after a number of attempts, turn the control dial to the off position
(clockwise) and also turn the cylinder valve off. Wait for five minutes before attempting to light the
BBQ again.
MAIN BURNERS
1.
Open the lid and make sure that all burners are in the OFF position.
2.
Connect the regulator to the gas bottle. Turn the gas supply to “ON” position on the regulator. Use
soapy water to check if there is any gas leakage between the gas bottle and the regulator.
3.
Push down the control dial and turn it anti-clockwise to the position, this will light the burner.
4.
If the burner fails to ignite, turn the control dial to the off position (clockwise) and also turn the
cylinder valve off. Wait 5 minutes and repeat step 3.
5.
Adjust the heat by turning the control dial between the High/Low markings on the control panel.
6.
To turn OFF the BBQ, turn the control dial clockwise to the “OFF” position and then turn the
cylinder valve or regulator switch to the “OFF” position, before disconnect
ing the gas bottle.
Before cooking for the first time, operate the BBQ for around 15 minutes with the lid closed and the
gas turned to HIGH. This will ‘heat clean’ the internal parts and dissipate odour from the painted
finish.
SIDE BURNER
1.
Push down the control dial and turn it anti-clockwise to the position to light the burner
2.
If the burner is not lit within 5 seconds, turn the dial to the OFF position, and repeat step 1.
3.
To turn OFF the BBQ, turn the control dial clockwise to the “OFF”
position and then turn the cylinder valve
or regulator switch to the “OFF” position, before disconnecting the gas bottle
Note:
The loose connection between side burner and valve is designed to allow air into the gas mix to ensure
the fuel is burned efficiently, and is not a fault with the unit.