Page | 16
35HP
–
Op Manual Rev 0 3/28/12
All specifications are subject to change without notice.
TOW BEHIND MACHINE
Uncoupling TL Unit
Caution: Failure to follow uncoupling instructions can result in unit rollover and serious
personal injury and unit damage.
DROP REAR STABILIZER LEG TO FIRM FLAT SURFACE.
Secure with spring loaded pin.
Disconnect taillight/brake wiring harness and safety chains.
Unlatch support jack and rotate to vertical position and lock.
Disconnect ball hitch/Pintle hook receiver on unit
Crank down support jack until ball hitch/Pintle hook receiver on unit clears ball hitch/Pintle
hook on towing vehicle.
Pull vehicle away from unit.
Towing Vehicle
Coupling TL Unit
Attach nozzle onto draw bar locking clip for transporting.
Securely attach unit to ball hitch/Pintle receiver.
Note: Confirm that Ball/Pintle hitch is secured.
Unit will detach from vehicle if not properly secured. Refer to manual for correct ball size.
Attach safety chains and connect taillight / brake wiring harness.
Raise rear stabilizer leg into upright position
Crank up support jack stand and unlatch; rotate jack until locked in the horizontal position
SKID MOUNT
Make sure that engine is turned off.
Turn fuel valve to the OFF position.
Check to insure that the carabineer chain on nozzle is secured (based on the units mounting
provisions)
After use make sure unit is secured
Transportation
Solutions
