11
Using Your Floor Steamer
Using Your Floor Steamer
Us
in
g Y
o
u
r F
lo
o
r S
tea
m
e
r
• Unplug the appliance from the electrical power outlet. This will stop
the Steamer from continuing to heat up.
• Once unplugged from the power outlet, place Handle in the “On”
position to release any residual steam and pressure from the Boiler.
• After all steam and pressure has been expressed from the Steamer,
return the Handle to the upright “Off” position.
• Slowly turn Boiler Cap counterclockwise. This will allow remaining
steam to escape.
•
Be sure Steamer has cooled 5 minutes before refilling with water.
The product warranty will be null and void if
anything other than water is added to the Boiler.
• Pour in 600 mls of water using the Measuring Cup
and Filler Funnel provided – fill the Measuring
Cup to the 200 ml marking 3 times.
Be careful
not to overfill the Boiler.
• Replace Boiler Cap by turning it clockwise.
Do
not tighten Boiler Cap too much – finger tighte
-
ning is sufficient to lock the steam in
the Boiler.
• Insert plug into 3-prong electrical outlet. Wait for
green Steam Ready Indicator Light to turn on. Steamer is ready to use
once again.
100 ml
200 ml
ANT
(Ma
x
*IMPORTANT*
Do not overfill the Boiler as excess water will be flushed out of the
Boiler before dry steam will emit.
REMINDERS
• Always use ordinary tap water.
• If tap water is too hard, use distilled or demineralized water to
avoid the risk of mineral deposits and sediment from forming.
• Do not add detergents, perfumes, oils or other chemical
substances to the Boiler. This will damage the Steamer and void the
warranty.
• The green Steam Ready Indicator Light may turn on and off during
use. This is normal and not a fault.
Summary of Contents for SC1Z1
Page 14: ...14 Notes Notes ...
Page 15: ...15 Notes Notes ...
