issues). The Group Numbers are “.0” to “.9”. Note, that a decimal point always
appears before the Group Number.
The Series 211 & 311 have only one Group and that Group Number is always
Group zero “.0”.
When each Issue is Saved, it is assigned an Issue Location Number. This
number has two parts. One part, the integer part (left of the decimal) is the Issue
Number and the other part, the decimal part, is the Group Number. An example
of Issue 20 in Group .4 is shown below.
The Issue Number can be assigned by you, or automatically by the Basys Point.
This is accomplished several ways:
1. Just press <SAVE ISSUE> and the next available slot will be assigned.
2. Input a number, say “20” and press <SAVE ISSUE>. This Issue will be
assigned to Issue #20
Both method #1 & #2 above will save the Issue in Group “.0” automatically.
3. Input a number say “20.4” and press <SAVE ISSUE>. This Issue will be
assigned to Issue #20 in Group Number “.4” (Series 411 only).
If an Issue exists in any location previously assigned to another Issue, you can
either over-write the existing Issue or assign a different location. A prompt will
appear and request an “over-write” or “clear” to assign another place. The prompt
is “OVERWRITE ISSUE 20.4 ?”.
The next page shows two examples of Saved Issues.
PAGE 19
Below are two samples of <SAVE ISSUE>
1. Issue #12 in Group #.0