7
USING THE WALL BRACKET
This vacuum includes a wall bracket for convenient storage when not in use. Perform the
following steps to install the wall bracket.
1.
Locate a section of wall with a nearby AC
power outlet for convenient charging. Ensure
that this location is not near heat sources and
not in direct sunlight.
2.
Using two screws or double sided adhesive
tape (not included), secure the Wall Bracket
(Hangar) to the wall. Ensure that the height is
sufficient to keep the appliance off the floor.
3.
Hang the vacuum on the Bracket by the
Handle, as shown in the image to the right.
CHARGING
This device uses a Lithium-ion battery. The battery should be charged before first use and
at least once every three months to keep the battery fresh and capable of holding a full
charge. Do not allow the battery to fully discharge.
1.
The three LED Indicators on the Handle show
the battery charge level. When only one
indicator is flashing green, stop using the
vacuum and charge the battery.
2.
Plug the DC barrel connector on the Charger
into the Charging Port on the Handle, then
plug the charger into a nearby AC power
adapter.
3.
When the three LED Indicators are solid green, the Battery is fully charged. A full
charge takes about 4-5 hours.
4.
Unplug the Charger from the wall outlet, then unplug it from the Handle.
