7
14.
Replace the rubber cap over the Water Filling Hole.
15.
Push forward on the Handle until the pole locks in place in the Mop Body.
16.
Slide the Lock Button on the Expandable Aluminum Pole upward to release the pole
lock, then push the pole fully in. Release the Lock Button to lock the pole length in
place.
17.
Remove the Mopping Cloths or Waxing Cloths from the spinning pads on the
bottom of the Mop Body, then rinse them in clean water to clean off any
accumulated dirt, detergent, wax, or other residue.
18.
Store the mop in cool, dry place.
TROUBLESHOOTING
Q1: The LED Light on the front of the Mop Body turns on, but the Start/Stop Button and
the Liquid Spray Button on the Handle do not respond.
A1: Replace the AAA batteries in the Handle.
Q2: Pressing the Liquid Spray Button does not spray liquid.
A2: Ensure that there is liquid in the Water Tank. Try pressing the button several times to
expel any air in the water feed tube.
Q3: The Nozzle is blocked.
A3: Use a needle or pin to clear the obstruction.
Q4: The Nozzle leaks.
A4: There may be solid particles in the water or wax mixture. Empty the Water Tank, rinse
it out, and add new liquid.