6
OPERATION
1.
Attach two Mopping Cloths or Waxing Cloths to the spinning pads on the bottom
of the Mop Body, depending on whether you want to clean or wax the floor. The
Mopping Cloths have a pink bottom and the Waxing Cloths are blue.
2.
Remove the rubber cap from the Water Filling Hole.
3.
Use the included Measuring Cup to pour water, water with detergent, or liquid wax
into the Water Tank.
4.
Replace the rubber cap over the Water Filling Hole.
5.
Step lightly onto the Power Switch ON/OFF to turn the spin mop on. The LED Light
on the front of the Mop Body will illuminate.
6.
Pull back the Handle to unlock the Expandable Aluminum Pole from the Mop Body.
For best results, the pole should be held at about am 80° angle while mopping.
7.
Slide the Lock Button on the Expandable Aluminum Pole upward to release the pole
lock, then slide the pole up or down until it is at a comfortable length. Release the
Lock Button to lock the pole length in place.
8.
Press the Liquid Spray Button on the handle to spray liquid onto the floor.
9.
Press the Start/Stop Button on the handle to start the spin mop. Press it again to
stop the spin mop operation.
10.
Use the Liquid Spray Button and Start/Stop Button as needed to mop or wax the
floor. Note that after 10 minutes of non-operation, the machine will enter Sleep
Mode. Step lightly on the Power Switch ON/OFF to wake it up.
11.
When you are finished mopping, press the Start/Stop Button on the handle to stop
the spin operation, then step lightly on the Power Switch ON/OFF on the Mop Body
to turn the mop off.
12.
Remove the rubber cap from the Water Filling Hole.
13.
Pull the Handle all the way back to make the mop as flat as possible. Invert the Mop
Body over a sink to empty the Water Tank of water. If you used detergent or wax,
rinse out the tank with clean water, then empty it again.
