10
AUTO LEVELING
Before you begin your first print, and anytime you remove the build plate, you should run
an auto-level to ensure that your models adhere properly to the build plate. Perform the
following steps to auto-level the printer.
1.
Ensure that the hotend is at room temperature.
2.
Connect the auto-level sensor to the green wire from the cable harness, then attach
the sensor's foam ring to the nozzle.
IMPORTANT: Use the minimum amount of force required to attach the sensor to the
nozzle. If the nozzle is touching the plastic membrane, it may prematurely trigger the
switch.
3.
Touch
>
>
AUTO LEVELING.