5
7.
HDBT OUT: RJ45 jack for connecting a Cat6 Ethernet cable for
transmission/reception of the signals.
8.
DC 12V: DC barrel connector for connecting the included AC power adapter.
Receiver
1.
MODE SWITCH: Put the Mode switch in the CTRL position for normal operation and
to allow RS-232 control pass-through. Put the switch in the UPDATE A position to
update the Valens IC program. Finally, put the switch in the UPDATE B position to
update the compression IC program.
2.
POWER LED: The LED illuminates red when power is applied.
3.
HDMI OUT: HDMI® port for connecting the display.
4.
Tx/Rx: 3-pin Phoenix block terminal connector for connecting an RS-232 control
device (PC) or a device to be controlled by RS-232 commands.
5.
IR IN: 3.5mm jack for connecting an IR receiver (not included).
6.
IR OUT: 3.5mm jack for connecting an IR emitter (not included).
7.
HDBT IN: RJ45 jack for connecting a Cat6 Ethernet cable for transmission/reception
of the signals.
8.
DC 12V: DC barrel connector for connecting the included AC power adapter.
CTRL
UPDATE B
UPDATE A
DC 12V
Tx
Rx
HDMI OUT
HDBT IN
IR OUT
IR IN
1
2
3
4
5
6
7
8
