Monoprice 612720, User Manual

Page: 6 / 8

6
3-pin XLR to 5-pin DMX Conversion
While most DMX compatible equipment uses 3-pin XLR connectors, some devices use
the official 5-pin DMX connector. To make a 3-pin to 5-pin converter simply make a
cable with a 3-pin XLR connector on one end and a 5-pin DMX connector on the other.
Connect the pins as follows:
3-pin XLR to 5-pin DMX Adapter
Signal 3-pin XLR 5-pin DMX
Ground/Shield 1 1
Data Compliment (- signal) 2 2
Data True (+ signal) 3 3
Do Not Use 4
Do Not Use 5
TROUBLESHOOTING
Following are some common problems and common solutions.
Problem:
The light will not turn on.
Solutions:

Check to ensure the power cord is connected to a power outlet.

Check to ensure that the connected outlet has available power.

Check to ensure the power switch is in the ON position.

Check to see if the fuse has blown, replace as necessary.
Problem:
The light will not execute DMX instructions.
Solutions:

Check to ensure that the light is connected to the controller via a DMX cable.

Check to ensure that the DMX chain is properly terminated.

Check to ensure that the DMX cable is good, swap out a known good cable to
test.

Check to ensure the light is in DMX mode (d001).

Check to ensure the DMX controller is operating properly.
If you experience other problems with this light and cannot solve them on your own,
please contact Monoprice Technical Support for assistance.