2
OPERATION
1.
Ensure that the volume levels of your instrument and sound system are set to the minimum.
2.
Plug a balanced XLR connector into your mixing console or stage snake, then plug the other
end into the XLR Output jack on the sound block.
3.
(Optional) Plug one end of a 1/4" cable into the 1/4" input on your amp, then plug the other
end into the 1/4" Parallel (Link) Output on the sound block.
4.
Plug a 1/4" TS cable into the 1/4" Input on the sound block, then plug the other end into any
unbalanced sound source (e.g., instrument).
5.
Increase the volume level of your sound source (e.g., instrument) to the 50% ~ 75% range.
6.
Increase the volume on your sound system to the desired level.
7.
If there is a buzz in the system originating from your instrument, use the Ground Lift Switch
to isolate your instrument from the sound system.
8.
If there is distortion from the input of the sound system, use the Attenuator Switch to
reduce the instrument's level by -20dB or -40dB.
SPECIFICATIONS
Instrument Input
1/4" unbalanced TS jack
Input Impedance
50 kilohms
Main Output
Balanced XLR jack
Main Output Impedance
600 ohms
Parallel (Link) Output
1/4" unbalanced TS jack
Parallel Output Impedance
50 kilohms
Input Attenuation
Switchable (0dB, -20dB, -40dB)
Ground Lift
Switchable
Construction
Steel
Dimensions
4.7" x 3.0" x 1.8" (120 x 76 x 45 mm)
