12
7.
Plug one end of the second AC Power Adapter into the DC 20V jack on the Right
satellite speaker. The LED will begin blinking blue.
8.
Press and hold the button on the soundbar for about 5 seconds. The LED
DISPLAY will show PAIRING.
9.
Within 15 seconds, press and hold the PAIR button on the Right satellite speaker
for about 5 seconds. The speaker will pair with the soundbar and the LED will
illuminate solid blue. The LED DISPLAY on the soundbar will return to showing
the currently selected input.
Final Steps
1.
If the soundbar is to be mounted on the wall, attach it to the two screws you
installed in the front wall earlier, otherwise position it on the table.
2.
Attach the two satellite speakers to the two screws you installed in the rear wall
earlier.
3.
Remove the battery compartment lid on the included IR Remote Control, then
install two AAA batteries (not included), paying attention to the polarity
markings in the battery compartment. Reinstall the battery compartment lid.
4.
Plug in and power on all connected equipment. Ensure that audio is playing on
each audio source device.
5.
Momentarily press the button on either the soundbar or the remote control
to cycle through the available inputs. Verify that audio is playing for each device.
Congratulations! Your new soundbar is installed and ready for use!
BLUETOOTH PAIRING
1.
Press the button on the soundbar to power it on.
2.
Momentarily press the button on the soundbar or remote control until the
LED DISPLAY on the soundbar shows bT. If the bT is blinking, the soundbar is in
Bluetooth® pairing mode. If the bT is not blinking, the soundbar is paired with
another device. If you want to change the pairing, press and hold the
►
▍▍
button on the remote control for about 3 seconds to delete the pairing. The bT
will be begin blinking to show that the soundbar is in Bluetooth pairing mode.