9
PHYSICAL INSTALLATION
WARNING!!! Prior to physical installation, use your circuit breaker
or fuse box to remove electric power from the room, then test
the circuit to ensure that electric power is not present.
1.
Remove the old switch and faceplate from the electric
box, then disconnect the wire leads.
2.
Connect the wire leads to the smart switch, as shown in
either the Single Switch or 3-Way Switch wiring diagrams
in the
WIRING DIAGRAMS section above.
3.
Check each wiring connection to ensure that it is secure
and that there are no stray wire strands.
4.
Insert the switch into the electric box, then secure the
switch to the box using two screws.
5.
Use the included screws to attach the faceplate to the
switch.
6.
Restore power at the circuit breaker or fuse box.
