2.1
Ceiling Mounting
2.1.1
Ceiling Mounting
without Inclined Base
Steps:
1.
Disassemble the dome camera by loosening three
screw of the bubble, and then take apart the bubble,
as shown in Figure 2-1.
Screw
Figure 2-1
Disassemble the Camera
Three screws on the bubble are all drop-proof screws. You
don’t have to loosen them completely.
The safety rope is hung on the bubble and the moun ng
base. Do not drag the camera in case of the damage.
2.
A ach the drill template (supplied) to the place
where you want to
fi
x the camera, and then drill the
screw holes and the cable hole in the ceiling
according to the drill template.
Drill Template
H ole A: for cab les r outed th rough t he ceiling
screw hole 1: for M ounting B ase
A
Figure 2-2
Drill Template
3.
Fix the moun ng base to the ceiling with the screws.
Figure 2-3
Fix the Moun ng Base and Camera
4.
Route the cables through the cable hole and
connect the video cables and power cord.
5.
Adjust the camera according to Figure 2-4 to get an
op mum angle.
1).
Rotate the camera body to adjust the pan angle
[0° to 355°].
2).
Loosening the T direc n screw to adjust the lt
angle [0° to 75°]. For 2.8mm lens models, the t
angle range is [0° to 65°].
3).
Rotate the camera body to adjust the rota n
posi n angle [0° to 355°].
