8
paper can be slid between the nozzle and the
platform without binding. When the extruder
head is moved or when the paper is moved
under it, there should be a slight amount of
resistance, but the paper should not be
dragged with the extruder when it is moved.
If the height is incorrect, use the included hex
wrench to make slight adjustments to the
platform height by turning the screws at each
corner of the platform. Turn the screws
clockwise to lower the platform and
counterclockwise to raise the platform. Turn
the wrench no more than 1/4 turn each time,
then recheck the height. Continue checking
and adjusting until the height is correct at all
points on the platform.
8.
Insert the included microSD
™
card into the slot
on the right side of the printer.
9.
Turn the printer on by depressing the I side of
the power switch on the rear panel.
10.
Rotate the control wheel clockwise to
highlight the Temperature entry, then press
the control wheel to open the Temperature
menu.
11.
Use the control wheel to highlight the Extruder
entry, then press the control wheel to edit the
value. Rotate the control wheel to set the
temperature to the target temperature for the
type of filament you plan on using.
12.
Using the same procedure, set the Platform temperature to the target temperature
for your filament type.
