Monogram ZIF360NHRH, Installation Instructions Manual

Page: 36 / 52

Custom Handles
• Custom handles must be used for flush installation. The
handle must be properly secured to the overlay panel
before sliding the panel into the trim.
• The cabinet manufacturer will supply the custom handle
and hardware.
• Discard the supplied handle.
• Slide assembled door panel into the trim.
• A trim cover kit has been supplied with your refrigerator. It
contains a piece of trim for both left and right door swing.
You will only need to use one piece of trim on the handle
side of your refrigerator in place of the trim piece you just
removed. Place trim against the side of the refrigerator
door, aligned top to bottom. The holes in the trim should
align to the holes in the door. Discard the other trim piece.
• Secure the new trim cover piece using the retained screws.
36
Installation Instructions - Flush Installation
Use Rear Holes
to Secure Trim
Use Front Holes
to Secure Handle
STEP 9 INSTALL OVERLAY PANELS
Install door panels:
• Open door to 90°. Remove the 6 Phillips head screws from
the door handle.
• Remove the handle.
• Remove the 6 screws holding the trim, then lift off the trim.
Retain the screws.
Install 6 Handle
Side Trim Screws
Refrigerator
Door
Custom Trim
Handle Side