Installation Instructions
STEP 2 REVERSE DOOR SWING
SKIP THIS STEP IF DOOR SWING SUITS THE
INSTALLATION
Parts Included:
• Top left case hinge
• Bottom left door hinge
Tools Needed:
• Phillips Screwdriver
• Torx Screwdriver–For case hinges
Note:
All parts will be reused except for bottom door hinge
and top case hinge.
To remove the door:
• Remove 2 screws holding toekick.
• Remove hinge plug cover on top left side of cabinet.
• Flatten the shipping carton to use as a pad for the
door.
• Remove the 3 screws holding the top case hinge.
• Lift off case hinge, it will not be used again.
• Lift door off bottom case hinge.
• Remove bottom case hinge with cam riser attached.
• Remove fill plug and screw on top right side of door.
• Remove door hinge (it will not be used again) and
screw from bottom right side of door.
Rotate the door:
Handle will be on right side of door, hinges will go on
the left.
Reinstall the Door:
• Install bottom case hinge and cam on the left side of
the unit.
• Install door hinge from kit to bottom left of door.
• Install fill plug and screw on top left of door.
• Place door on bottom case hinge.
• Install top case hinge from kit on top left of cabinet.
• Install hinge plug cover on top right of unit.
• Move plug on toekick to opposite side.
• Install toekick.
Verify that spacers are still attached to
the rear of the toekick.
• Install Monogram badge on door.
• Put remaining case and door hinge in bag for possible
future use.
Note:
Verify that door is on straight and screws are
tightened. If not the door will sag.
Position badge:
See the back cover for instructions and template to
accurately locate the supplied badge.
5
Remove
Top Hinge
Move Bottom Hinge
to Left Side
Door Stop
Install
3 Hinge
Screws
Summary of Contents for ZDWC240NBS
Page 7: ...7 ...