Monogram ZDBC240, Installation Instructions Manual, Page: 7 / 24

31-46122-7
7
Turn Right to Lower
Turn Left to Raise
Installation Instructions
STEP 3 LEVEL
• Use an adjustable wrench to turn the leveling legs and
raise or lower the product.
• Adjust carefully; the product should be level and plumb
with cabinetry, and should align with adjacent toekick
height.
If you skipped Step 2:
• Select the hinge cover marked “R” or “L”, depending on
door swing.
• Peel backing off the tape inside the decorative hinge
cover. Press and snap into position.
• Snap the screw hole cover into place on the opposite
side.
STEP 4 CONNECT POWER
• Connect power cord plug to a properly grounded re-
ceptacle.
• Check to make sure power is on by opening the door
to see if interior light turns on.
STEP 6 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to the
Owner’s Manual for more information. Allow 24 hours
for temperature to stabilize.
STEP 5 SLIDE PRODUCT INTO THE
CUTOUT
• Carefully, slide the unit into the opening. Be careful not
to entangle the power cord.
• Make certain that the door protrudes 1″ beyond the
surrounding cabinets (1-7/8″ for custom frame models).
• Check again to be sure the unit is level.
STEP 2 REVERSE DOOR SWING
(Cont.)
Install Toekick
The toekick has a cutout on the left and right sides.
Remove the plug on the left side and reinstall on the
right side. If you choose to install the stainless steel
toekick, reinstall the plug on the right side of that toekick.
• Install original screws
and spacers or screws
and spacers supplied
with the stainless steel
toekick. Install screws
through the spacer
standoff, toekick and into
the base as shown.