III. ORDER OF OPERATIONS
It is important to understand the order of operations for activating your ALTA Carbon
Monoxide Sensor. If done out of place, your meter may have trouble communicating with
iMonnit. Please consult the steps below to make sure you are performing your setup
correctly.
SET UP STEPS
1. Register your gateway on iMonnit.
Your gateway must be registered first to verify communication between the device and
iMonnit. Any sensors or meters you wish to add onto your network must come after the
gateway.
2. Register your Carbon Monoxide Sensor on iMonnit.
After you’ve registered your gateway, it’s time to add your CO Sensor to the iMonnit
account.
3. Install batteries in your sensor.
After your sensor is added and your gateway is communicating with iMonnit, you can install
the batteries. Your CO Sensor runs on AA batteries.
4. Mount your sensor.
Place your sensor in the desired spot using screws or double-sided tape. Make sure you
have the correct antenna orientation to receive a strong signal.
Each of these steps are covered in more detail in the following sections.
PAGE 3
