21
FEATURES REAR PANEL
1.
Vent Port
2. Volume Knob: This knob adjusts the gain level. When operating the unit for the first time, start with the
volume control set all the way off. Slowly raise the volume control to reach a comfortable listening
level.
3. Xover Frequency – Knob: With this knob you are able to adjust the Crossover frequency between 40Hz
and 120Hz.
4. Phase reverse switch: 0°/180°
5. Standby-mode switch: 3 choosable modes ON/AUTO (incomming signal)/OFF
6. XLR 4dBu):This inputs accepts XLR type connectors. Connect your audio interface, mixer, or
other line-level audio source to this inputs.
7. 6,3 mmTRS 4dBu): This inputs accepts TRS 6,3mm type connectors. Connect your audio
interface, mixer, or other line-level audio source to this inputs.
8. RCA Inputs (-10dBv): The RCA inputs accepts unbalanced signals used to connect signals from
unbalanced -10dB devices.
9. S/PDIF Input: S/PDIF - coaxial digital input
10. XLR – Out: Connect these outputs with the input of your studio monitor or any other compatible devices.
12. Power Switch: This Switch powers on and off.
13. AC Inlet: This socket accepts a standart IEC-type power cable.
14. Sub Bypass: Here you can connect your subwoofer with an optional footswitch to mute the subwoofer.
ATTENTION! Please do not connect audio signals with this input!
15. TRS Out: Connect these outputs with the input of your studio monitor or any other compatible devices.
16. RCA Out: Connect these outputs with the input of your studio monitor or any other compatible devices.
FEATURES FRONT PANEL
15. LED Logo : The Monkey Banana Logo will be lighted as soon as signal source is playing.
After 12 min without ( no signal is playing) the speaker turns into Standby Mode, the Logo will be
dimmed; the speaker is in “Jungle Protect” - according to [European Directive 2005/32/EG].
As soon as signal is played again the speaker turns on immediately, the Logo will be relighted
ENGLISH
