1
draw around template and mark
centre lines if necessary
CUSTOM INSTALLATION SERIES
Tri-Grip x 3
= 5Kgf/cm; 4.34 lbf/inch; 0.5 NM
CT180, CT180-T2, CT280
247mm (9
3/4
”)
121mm (4
3/4
”)
247mm (9
3/4
”)
156mm (6
1/8
”)
CT280-IDC, CT380-IDC, CT380-FX
Template
cut around marked line
2
3
connect speaker cables by pushing
down on the terminals and clamping
the bare wire in the through hole.
5
tighten 3 tri-grip screws on the
inceiling models or the 6 tri-grip
screws on the in wall models.
see over
tightening
warning.
6
Fit grilles. they are held in place
magnetically and should ‘snap’ into
place.
Fitting the custom install loudspeakers
4
guide speaker into cut out
CI Trimless Manual ~ Full ~ Multi Lang.indd 4
29/05/2012 15:07:04