Dig a hole in the intended location for the
subwoofer and fill the base of the hole
with sharp sand. This is to improve stability, assist
in levelling and prevent the sub from rocking in
place.
Approximate hole dimensions (H x W x D):
600 x 600 x 400mm (CLGW-12)
400 x 400 x 310mm (CLGW-10)
Sand depth: 150mm (6”)
3
1
2
Sharp sand
Dig a shallow trench along the path of
where you wish to run the subwoofer’s
speaker cables. If using the CLG140/ CLG160
speakers there is no reason the cables for these
cannot be doubled up in the same trench as the
subwoofer’s speaker cables.
Place the subwoofer in the hole and push it
into the sand so that it stays still and can
be levelled/ made square.
CLG-W10 NOTE:
There must be at least 100mm of
cabinet above ground level.
NOTE: Ensure the system is tested and working correctly before filling in around the subwoofer and cable tenches.
NOTE: The bass from the CLG-W10/ CLG-W12 will not be as full or prominent until the hole is filled in.
Installation
Please follow the following steps in the below section for burying the CLGW12 or CLGW10 in the ground. Alternitavley for
securing the CLGW10 to a hard floor refer to page 5.
CLG-W10/ CLG-W12
Climate Garden Series
2
4
Connect cables to subwoofer. For 100/70v
lines connect to the black and red cables,
for conventional 8 ohm lines connect to the yellow
and black. Where black is the negative.
Connections
should be made
with either
silicone filled
wire connectors
or appropriate
weather proof junction box (not included).
Note: Ensure that no ‘-’ and ‘+’ strands are
touching each other as this will cause a short
circuit that could damage your amplifer.
To Next CLG-W10/
CLG-W12 (optional)
To CLG-W10/
CLG-W12
From previous
speaker/ amp
ENGLISH
