9
Instruction
Text to send to tracker
Reply
Low power alert
(once voltage below 3.7v)
Warning, low power !
If main power
disconnected
pwr0
pwr1
pwr2
pwr3
No alerts
SMS alert
Phone call alert
SMS then call alert
Language
LAG1
(English)
LAG2
(Chinese)
Switched to XXX
Check tracker
status
Shows current status
Reset
format
Re-sets all settings to default
Re-boot
RST
Re-starts the tracker
SIM CARD INSTALLATION –
From March 2018, use only Vodafone SIM cards (not 4G data cards)
Make sure that the 2G mobile GSM SIM card is operational (activated with its supplier) by testing
in a mobile phone. It cannot be activated when inside the tracker.
•
Do not insert SIM card with power cable connected – you could damage the SIM card.
•
Do not activate call transfer.
•
Make sure that any SIM card PIN code is turned off.
•
Do not hide your mobile phones identity.
•
Keep SIM credit up to date – make a note of the top-up date.
Add this SIM to your phones ‘contacts’, such as “GPS TRACKER” so you know where alerts have
come from.
SIM CARD
•
Carefully lift up the SIM card/USB charger rubber cover –
DO NOT REMOVE THE DUST/WATER COVER.
•
Insert the SIM card correctly, as shown. It will click into place.
•
Fully replace the rubber cover to ensure a good seal.
NOTE: Inserting the SIM turns on the battery back-up. If not using
the tracker, always remove the SIM card.
LED’s (under the rubber cover) – WHAT THEY MEAN
Green LED — Mobile GPRS signal state
Unlit
GSM off
Lit solid
Searching
Flashing once every 3 sec’s
GPRS working
Blue LED – GPS signal state
Unlit
GPS off
Lit solid
Searching
Flashing once every 3 sec’s
GPS working
