14
27D7300
#1
#2
#3
#4
#5
#6
2"
FILLING THE BURNER PAN
Fill the burner pan with vermiculite to the bottom of the rear log and sloped to the front edge of the burner pan. Excess ver-
miculite can spill forward or to the side of the burner pan. Do not overfi ll the propane model. Do not cover the pilot (if SPK
or MVVK is installed) with vermiculite or rock wool (embers).
PLACEMENT OF GLOWING EMBERS (ROCK WOOL)
The Wildfi re fl ame appearance can vary due to differences in draft and fi replace confi gurations and ember placement. After
installing rear (#1) and front logs (#2 and #3), cover the entire top surface of the vermiculite in the burner pan with the rock
wool supplied with unit. Tear the rock wool into pieces approximately
1
/
2
" in size (roughly the size of a nickel) and cover the
burner evenly. Do no use more rock wool than the amount supplied with the unit. To enhance the appearance of the Wildfi re
fl ame, it is recommended to form a mound of rock wool in the center of the burner, 2" to 3" high, visible through the two
front logs.
PLACEMENT OF DECORATIVE VOLCANIC ROCK
Sprinkle volcanic rock in front of front glowing embers and to both sides.
DO NOT SPRINKLE ON BURNERS, EMBER BED, PILOT OR LOGS.
IMPORTANT: Do not handle logs with your bare hands! Always wear gloves to prevent skin irritation
from ceramic fi bers. After handling logs, wash your hands gently with soap and water to remove any
traces of fi bers.
LOG PLACEMENT
Figure 17 - VWF18MO (Massive Oak)
Log Placement
VWF18MO LOG PLACEMENT
(6 Logs)
1. Slide shield plate down back of burner pan.
See
Figure 17
.
2. Center rear log #1 on grate bars and fl ush with rear of
the grate.
See Figure 17.
3. Place front left log #2 on the front of the plate and to the
left.
See Figure 17.
4. Place front right log #3 on the front of the plate and to
the right.
See Figure 17.
NOTE: Allow 2" between the back log and the
two front logs.
5. Install left crossover log #4 as shown.
See Figure 17.
6. Install right crossover log #5 as shown.
See Figure 17.
7. Install top log #6 as shown.
See Figure 17.
Shield
Plate