4
79D0004
NOTICE
Illustrations shown in this manual refl ect “typical” installations with nominal
dimensions and are for design and framing reference only. Actual installations may
vary due to individual design preferences. However, always maintain minimum
clearances to combustible materials and do not violate any specifi c installation
requirements.
GENERAL INSTALLATION INFORMATION
DO NOT ATTEMPT TO BURN SOLID WOOD FUELS, VENTED GAS LOG SETS, OR ANY OTHER COM-
BUSTIBLE IN THIS UNVENTED FIREBOX. ALSO, DO NOT INSTALL A VENT-FREE GAS LOG SET IN THIS
FIREBOX IF THE MINIMUM CLEARANCE AND HEIGHT REQUIREMENTS OF THE LOG SET ARE TOO
LARGE FOR THE FIREBOX.
The LSTF36, LPF36, LRCF36, and LLCF36 Series are vent-free fireboxes. They feature a self-contained heat-circulating
system. These units also feature a 2-in-1 flexible-face system (except for corner unit) that converts the circulating system
into a radiant system in seconds.
This installation manual will enable you to obtain a safe, efficient, and dependable installation of your vent-free
fireplace system.
Do not alter or modify the firebox or its components under any circumstances. Any modification or alteration of the firebox
system, including but not limited to the firebox and accessories, may void the warranty, listings and approvals of this system
and could result in an unsafe and potentially dangerous installation.
BEFORE YOU START:
CHECK YOUR PACKING LIST TO VERIFY THAT ALL LISTED PARTS HAVE BEEN RECEIVED.
ALSO INSPECT THE CONTENTS FOR SHIPPING DAMAGE AND IMMEDIATELY INFORM YOUR DEALER
IF ANY DAMAGE IS FOUND.
You should have the following:
1. Vent-Free Gas Firebox
2. One (1) - 36" Canopy (LRCF36/LLCF36)
One (1) - 20" Canopy (LRCF36/LLCF36)
Two (2) - 36" Canopys (LSTF36/LPF36)
3. Installation and Operating Instructions
4. Five (5) drywall spacers
ITEMS
REQUIRED
FOR
INSTALLATION
TOOLS:
BUILDING
SUPPLIES:
Phillips screwdriver
Square
Framing materials
Hammer
Piping complying with local codes
Wall finishing materials
Saw and/or saber saw
Tee joint
Caulking material
(noncombustible)
Level
Pipe wrench
Fireplace surround materials
(noncombustible)
Measuring tape
Pliers
Electric drill and bits
Pipe sealant approved for use
with
propane/LPG
(resistant to sulfur compounds)
Refer to the installation instructions provided with the log sets for items required for log set installation.
