33
NB18/NB24 Gas Log Set
Monessen • NB18/24 Gas Log Set Installation/Owner's Manual • 81D0107 • Rev E • 04/18
FEATURES
Command Center
•
Easy access function operation and system configu-
ration
•
Operation confirmation/fault diagnostic indications
(LED/Buzzer)
•
ON/OFF/HI/Med/Low operation
•
Optional wall mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save
battery
•
6-hour Automatic Shut Down Option
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
Transmitter (Options)
(TSTSC is supplied with R-Models) TSTSC TSMSC
Three Flame Height Settings
X
X
Low battery Indication for Transmitter X
X
Child Proof Lock-out
X
X
LCD Backlight
X
X
Security Codes 10,000
X
X
Countdown 6 hr Timer
X
X
Standard Thermostatic Control Mode X
--
Smart Mode
®
Thermostat
(Auto Flame)
X
--
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries to
operate the system.
To Install Batteries:
1. Press down the battery door tabs and pull out to remove
battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system is
ready to operate.
5. The batteries should be replaced when the LED indi-
cates low battery or at least once a year.
FP1917
Signature components
8/08
RF Receiver
ON/OFF
NG/LP
Conversion
To Thermopile
To Sensor
To Sparker
To Command
Center
To Stepper Motor
To Valve
Battery Door
Master Switch
ON
LED
OFF
Control
Board
Command Center
Figure 53 -
Signature Command System Components
SYSTEM CONFIGURATION/SETUP
All System configuration/setup is done on the Command
Center.
NOTE:
When using On/Off wall switch, the switch must be
in the ON position to perform all configuration set ups at
the command center.
COLD CLIMATE OPTION
Choose the Mode That Best Suits Your Needs
The Signature Command System is designed to operate
in either Standing Pilot or Intermittent Pilot mode.
•
The Standing Pilot Mode is best for colder climates
when the pilot must remain on continuously to prevent
condensation and ensure reliable operation.
•
The Intermittent Pilot Mode is ideal for maximum effi-
ciency, igniting the pilot only when needed to start your
fireplace, lowering fuel consumption and reducing your
carbon footprint.
OPERATING INSTRUCTIONS — SIGNATURE COMMAND SYSTEM
Summary of Contents for BC18-R
Page 53: ......
