Moneris smartselect, Operating Manual

Page: 43 / 198

SmartSELECT Merchant Operating Manual v 2.0 33
Configuring Your Terminal
4.8: Dial Communications Parameters
If your terminal will being communicating with the Moneris Host over a standard
analog line, you will need to set up these parameters.
This process sets up all the parameters in the order they are listed in on the
Dial
Communications Setup
menu.
If the parameter’s default value displayed on the
Dial Communications Setup
menu is acceptable, you do not need to access that prompt. Simply select the next
list item that needs to be changed.
If you access a prompt and decide to keep the default value, simply press
Enter
to
keep that value and return to the
Dial Communications Setup
menu.
From the Idle screen:
1. Press
Menu
. The
Financial Transactions
menu appears.
2. Press
Config
. The
Terminal Configuration
menu appears.
3. Select
General Parameters
. The
General Parameters
menu appears.
4. Ensure that Dial is selected as the communications type:
a. Select
Communications Type
. The
Communications Type
menu
appears.
b. Select
Dial
. The
General Parameters
menu reappears.
c. Press
Exit
. The
Terminal Configuration
menu reappears.
5. Select
Dial Communications
. The
Dial Communications Setup
menu
appears with a list of parameters and their current values.
6. To change the PBX Prefixes for the seven-digit local telephone number and
the ten-digit long distance telephone number to the Moneris host:
Note: These fields are optional.
a. Select
Local PBX Prefix
. The
Enter Local PBX Prefix
prompt appears.
b. Key in the local PBX prefix (min. 1 digit, max. 20 digits, e.g. 9) and press
Enter
. The
Dial Communications Setup
menu reappears.
• If you wish to force the terminal to use pulse dialling, press the
Pulse
Dial
button to enter a “P” before the prefix.
c. Select
Long Dist PBX Prefix
. The
Enter Long Distance PBX Prefix
prompt
appears.
d. Key in the long distance PBX prefix (min. 1 digit, max. 20 digits, e.g. 1
800) and press
Enter
. The
Dial Communications Setup
menu reappears.
• If you wish to force the terminal to use pulse dialling, press the
Pulse
Dial
button to enter a “P” before the prefix.
7. To change the modem speed for the primary and backup lines:
a. Select
Primary Line Speed
. The
Primary Line Speed?
prompt appears.
b. Select the list item with the appropriate Baud rate. The default is 2400
Baud. The
Dial Communications Setup
menu reappears.
c. Select
Backup Line Speed
. The
Backup Line Speed?
prompt appears.
d. Select the list item with the appropriate Baud rate. The default is 2400
Baud. The
Dial Communications Setup
menu reappears.