Monark 828 novo mini, Manual

Page: 16 / 20

16 MONARK 828 E
1
3
2
4
5
1
2
3
6
1
ENGLISH
CALIBRATION PENDULUM
Fig:
Calibration
1) Calibration weight, 4 kg
2) Kp-scale
3) Attachment of calibration weight
4) Pointer at 4 kp
5) Screw to adjustment weight
6) Here you insert the string behind the cover
SCALE - ZERO ADJUSTMENT
Check that the pendulum will hang in vertical position.
Scale board:
Check that the index on the pendulum weigh is aligned
with the index at the 0-position on the scale board. If
adjustment is necessary, first loosen the locknut and
then change the position of the scale board. Tighten the
locknut after the adjustment. See Fig: Zero adjustment.
Kp-scale:
At the same time, check that the kilopond-scale to
the left of the meter, shows 0 in line with the index.
To adjust the kp-scale loosen the lock screw for scale
indicator. Tighten the screw firmly after the adjustment.
See Fig: Calibration and Adjustment kp-scale window
Fig: Adjustment kp-scale window
9) Lock screw for scale indicator
Fig: Zero adjustment
1) Locking nut
2) 0-index
3) Adjustment weight, pendulum
All ergometers are carefully calibrated at the factory.
You can check the calibration if you want to verify this,
if so, proceed as follows:
Be sure that the scale board is set to zero before the
weight is put on, see section ”Scale - zero adjustment”.
Remove the brake belt from the spring. Thread the
calibration weight string from below, inside the frame
cover, so the string is between the flywheel and the
frame cover. Hook the string into the spring. If the
calibration is correct, it is possible to read this weight
from the corresponding place on the scale board.See Fig:
Calibration.
If there is a deviation, adjust the pendulum to the right
position on the scale by adjusting the weight inside the
pendulum. See Fig: Zero adjustment. To change the
position of the adjusting weight, loosen the lock screw
on the back of the pendulum weight. If the pointer
shows too low, the internal weight must be moved
upwards. If the pointer shows too high, the adjustment
weight is moved down. This process is repeated until
pointer is in the correct position.
Check the calibration of the pendulum weight once a
year or when needed.