10
2.
Hold the lamp with a cloth between your forefinger and thumb and
rock it back and forth gently while pulling out. Do not attempt to rotate
the lamp. The lamp is socketed and will come out easily when pulled
straight out.
WARNING: Do NOT touch the new lamp with bare fingers.
3.
Using a lint-free cloth, insert the new lamp by gently rocking the lamp
while pushing it into place (see Figure 6). Make sure the lamp is in
straight and centered in the reflector hole.
L-1905 Lamp
Note: Older PALM STROBES and flashtubes
may have a red dot (
•
) on the
flashtube and connector to indicate
polarity. If present, match red to red.
Figure 6 Lamp Replacement
4.
Reinstall the reflector (if necessary) and then position the front lens in
place matching up the notches on the lens with the two small tabs on
the housing to prevent lens rotation (see Figure 6). Stretch the rubber
bumper over the top and bottom case halves to seal in the reflector
and front lens.
