Monacor JTS 25.7300, Instruction Manual, Page: 9 / 24

9
True Diversity UHF Receiver
for MH-36G2/5 and PT-36BG2/5
These instructions are intended for users without
any specific technical knowledge Please read
the instructions carefully prior to operation and
keep them for later reference The operating ele-
ments and connections described can be found
on page 2
Contents
1 Operating Elements and
Connections
1 Receiving antennas
2 Volume control
3 LED bar graph RF for the strength of the radio
signal received
4 LED bar graph AF for the volume of the audio
signal received
5
Display
Indication Meaning
…
MHz
transmission frequency
G … CH … group number and channel number
when the transmission frequency has
been set via the function “GROUP”
when the transmission frequency has
been set via the function “FREQ”
MUTE
muting of the receiver
– when no signal is received from the
transmitter or when the signal is poor
– when the transmitter is muted
diversity indication A or B: to show which
of the two receiver sections receives the
radio signal of the higher quality; there
will be no diversity indication when the
receiver is muted
battery symbol: to indicate the battery
status of the transmitter in multiple levels;
there will be no battery symbol when the
receiver is muted
SQ … value for the squelch function
ATT ON
level attenuation for the XLR output (11)
by 20 dB
LOCK
key lock;
when the key lock has been activated and
a button is pressed, the message
will appear
Note: When the batteries of the transmitter are
almost discharged, the display backlight will change
to red
6 Buttons SET,

and

to make settings: refer
to chapter 6
7 Button POWER to switch on (press the but-
ton briefly) and switch off (keep the button
pressed for 2 seconds)
Overview of groups and channels 3
English
1 Operating Elements and Connections 9
2 Safety Notes 10
3 Applications
10
3.1 Conformity and approval 10
4 Connection 10
5 Switching on/off 11
6 Settings 11
6.1 Function “GROUP”:
Selecting a frequency from a group 11
6.2 Function “FREQ”:
Setting the frequency directly 11
6.3 Function “SCAN”:
Skipping channels already being used
when selecting channels
12
6.4 Function “SQ”: Setting the squelch value 12
6.5 Function “ATT”:
Level attenuation for the XLR output 12
6.6 Function “LOCK”: Key lock 12
7 Setting up a Transmission Path 13
8 Specifications 13
English
English Page