Version 2.1
NU_CTS100_001_12112010_EN
2
Power indicator: When the unit power on, the led will flash 1time/3sec by green. If the
power has low status, the LED will change to red, and the red LED will keep on when
charging mode. Even battery charge finished, the power LED will change to green. If
tamper switch is triggered, the power indicator will flash twice continuously; if door
sensor is triggered, the power indicator will flash 5 times continuously
GPS indicator: LED is GREEN when the unit has acquired a valid GPS signal, and it will
flash when the unit is searching GPS signal.
GSM/GPRS indicator: Orange LED will flash when the device is connected to the server
with valid GPRS connection. It will stay continuously on when it is in GSM mode. It will
stay off if there is no GSM reception.
Note that the GSM/GPRS and GPS LED’s indication will not be valid until the system
goes to the working mode, normally 30 seconds after power on.
II.
The main unit’s housing with Strong Magnetic Gives You Easy Instant Install
Placement!
Just like we put you in control on how and when your CTS100 reports to you with your
own online controls, we also put YOU in control of how you want your CTS100 installed
on any container or vehicle.
In addition, the unit has built-in door magnetic sensor, it used to detect the container
door status.
III. BASIC FUNCTIONS
FUNCTIONS
APPLICATIONS
GPS
GPS receiver will output a complete position, velocity, and time
(PVT) solution in the NMEA Version 3.0 protocol.
GPRS, SMS
GPRS use standard TCP or UDP communicate protocol. If the GPRS
service is failed, the SMS mode will be turned on for emergency
use.
Button
Power switch
PC-setup
Initialize the unit and program the device, including Network APN,
server IP address, user message, report control, and Geo-fence
setting, etc …
Note that Network APN and server IP details must be set before the
installation.
Standard Report
Automatic report for tracking purpose:
Fixed time report
Fixed distance report
Trigger report
History data store 900 reports can be saved in unit and read from server and pc-setup
