RHT2251 Hand Crimp Tool
Doc No. 64001-4800 Release Date: 10-07-04
UNCONTROLLED COPY
Page 5 of 7
Revision: A
Revision Date: 10-07-04
Tool Calibration
A Certificate of Calibration (see last page) was supplied with
the tool. To recalibrate this tool, pin gauge measurements
should be taken in each conductor nest and compared to this
chart. The tool should be lubricated prior to recalibration to
ensure consistent measurements. Handle preload is factory set
to 25-45 LBS. See How to Adjust Tool Preload (see Figure 6)
to recalibrate.
Wire
Range
“X” Dimension
Conductor Crimp
Nest Color Code
AWG mm² Mean
Go
No
Go
Crimp Inspection
Marking
Yellow
10 - 12
5.00 –
3.00 .127 .124 .132
o
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials.
All vital components are long life tested. All tools are warranted to be free of manufacturing defects for a
period of 30 days. Should such a defect occur, we will repair or exchange the tool free of charge. This
repair or exchange will not be applicable to altered, misused or damaged tools. This tool is designed for
hand use only. Any clamping, fixturing, or use of handle extensions voids this warranty.
Hand held crimping tools are intended for low volume, prototyping, or repair requirements only.
Caution: Repetitive use of this tool should be avoided.
PIN GAUGE IN
CONDUCTOR
“ CONFINING”
X