A.S. 04.03.15/ISSUE D
FILENAME: SD-69008-0140
SET-UP
1)
Fix upper block onto Arbor Press spindle and tighten locking
screw.
2)
Place lower termination fixture onto mounting platform of
Arbor Press.
3)
Make a few samples following the next section (operation)
and then check termination heights. If adjustment is
required see adjustments section.
OPERATION
1)
Insert connector into lower termination block.
2)
Push pre-stripped cable into connector.
3)
Pull handle down fully to terminate connector.
4)
Turn handle to start position.
5)
Release connector latch and SLIDE harness backwards out of
fixture.
