AT7050 Air Crimp Tool Head
Doc No. 64005-0900
Release Date: 10-10-02
UNCONTROLLED COPY
Page 4 of 7
Revision: F
Revision Date: 05-11-05
Maintenance
It is recommended that each operator of the tool be made aware of,
and responsible for, the following maintenance steps:
1. Remove dust, moisture and other contaminants with a clean brush,
or soft, lint-free cloth.
2. Do not use any abrasive materials that could damage the tool.
3. Make certain all pins; pivot points and bearing surfaces are
protected with a thin coat of high quality machine oil. Do not oil
excessively. The 64005-0900 (AT-7050) was engineered for
durability, but like any fine piece of equipment it needs cleaning
and lubrication for a maximum service life of trouble-free
crimping. A light oil, such as 30 weight automotive oil used at the
oil points shown in Figure 4, every 5,000 crimps or monthly will
significantly enhance the tool life and ensure a stable calibration.
4. When tool is not in use store the tool in a clean, dry area.
Tool Calibration
A Certificate of Calibration (see last page) was supplied with the tool. To
recalibrate this tool, pin gauge measurements should be taken in each
conductor nest and compared to this chart. The tool should be lubricated
prior to recalibration to ensure consistent measurements.
Wire Range
“X” Dimension
Conductor Crimp
AWG mm² Mean
Go
No
Go
12 - 22
0.35 – 3.30
.102
.099
.106
Warranty
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital components are
long-life tested. All tools are warranted to be free of manufacturing defects for a period of
30 days.
Should such a defect occur,
we would repair or exchange the tool free of charge. This repair or exchange will not be applicable to alter, misused or damaged
tools.
PIN GAUGE IN
CONDUCTOR CRIMP
“ Confining ” Crimp
X
LUBRICATION POINTS
(BOTH SIDES)
LIGHT OIL (EVERY MONTH
OR 5,000 CRIMPS)
Figure 4
