Hand Crimp Tool for SL™ Crimp Terminals
Doc No. ATS-638118700
Release Date: 07-30-07
UNCONTROLLED COPY
Page 4 of 8
Revision: C
Revision Date: 03-29-12
Figure 5
TERMINAL
WIRE
AGAINST THE
WIRE STOP
WIRE
WIRE STOP IS PART OF
THE LOCATOR
PRE-STRIPPED
WIRE
TERMINAL
Note: The tamper proof ratchet action will not release the tool until it has been fully closed.
8.
Remove the crimped terminal from the terminal
locator by pulling on the wire.
9.
Visually inspect the crimped terminal for proper
crimp location.
10.
On some large O.D. wires, it may not be possible
to insert the wire with the tool partially closed.
Those wires should be inserted with the hand tool
in the open position. Insert the wire above the
terminal in the punch and against the wire stop
then close the tool. See Figure 6.
Locator Replacement
See the parts list on the last page of this document
for the proper locator order number. Follow the
steps below to replace the locator.
1.
Open the crimp hand tool.
2.
Squeeze gently on the lower area shown in
Figure 7A with your thumb and index finger.
The lower tabs of the locator should disengage
from the hand tool.
3.
Lift and pull away from the hand tool. The top
locator hooks should slip out of the top slots
easily. See Figure 7A.
4.
To reinstall the new locator, make sure the
hand tool is in the open position.
5.
Press the red insert down as far as it will go as
shown in Figure 7B.
6.
Holding onto the lower part of the locator with
your thumb and index finger, insert the locators
top hooks (2) into the hand tool top slots.
7.
Rotate the locator down and press the lower
tabs into the two bottom slots of the hand tool. To secure the locator into place, the lower tabs must snap into
place on the hand tool frame.
TERMINAL
Figure 6
WIRE
WIRE STOP
SQUEEZE
HERE
LOCATOR
Figure 7A
SQUEEZE
HERE
TOP HOOKS
TOP SLOTS OF
HANDTOOL
LOWER TABS
MAKE SURE
CENTER OF LOCATOR
IS IN THE
DOWN POSITION
Figure 7B