Page 12
5.4. Adjustment Method of Wire Pusher Bottom Dead Point
1) Loosen the “nut (2)” of the “shank (1)” on the hand press and adjust the bottom dead point of
the wire pusher turning the “shank (1).” Tighten the nut after it adjusts and the shank is
fixed to the “ram (3).”
2) Amount of adjustment and direction
[Amount of adjustment]
One scale = about 0.17mm (One rotation =1.0mm)
[Direction of adjustment]
The wire is deeply pushed: Shank is turned left.
The wire is shallowly pushed: Shank is turned right.
3) The “stopper (4)” is adjusted in the position with the space of 0.5mm from the “upper die set
(5)” at the bottom dead point of the tool.
* The stopper is for interference prevention of the upper and lower when the die set is
removed from the hand press.
“Note”
Please start the work after confirming that the wires are surely pushed into the upper
cover without crushing after adjustment.
Shank (1)
Nut (2)
Ram (3)
Upper die set (4)
Stopper (5)
