Page 7
4.3. Wire Arrangement
1) Set a “wire (1)” in the ditch of a prescribed circuit number of the “wire guide comb (2)”
according to the wire arrangement table.
2) At this time, push the “wire (1)” firmly from both sides into the ditch of the “wire guide comb
(2)” while giving a tension light so that the wire should not slacken.
3) When the arrangement of all wires is finished, take the slack of the wire depressing an
“inside wire (4)” of the wire guide comb with the “wire arrangement tool (3).”
“Note”
It is a prohibition because the wire pushing in the state that there is slack in the wire
causes a defective cutting. Please take the slack of the arranged wire surely.
Wire (1)
Wire guide comb (2)
Wire trimming tool (3)
Wire guide comb (2)
Inside wire (4)
Upper cover
Upper cover
