10
Filter Replacement and Care (con’t)
Cleaning and Maintenance
5. Take note of the filter position.
Remove the filter. You may want
to clean the base at this time. See
the “Cleaning and Maintenance”
section of this manual.
6. Install a new filter (MAF-2) into
the base. Position the filter
between the uprights in the bottom
of the base. The filter should be
resting on the floor of the base.
7. Return the upper housing to the
base by first placing the hooks
located near the front of the base
into the mating holes in the upper
housing. Then tilt the upper
housing down towards the base
until the rear snap engages the
main housing.
8. Reposition the humidifier to its
operating position.
9. The humidifier is now ready to
be filled for operation.
WARNING:
To reduce the risk of
injury, fire or damage to humidifier,
use only cleaners specifically
recommended for humidifiers.
Never use flammable, combustible
or poisonous materials to clean your
humidifier. To reduce the risk of
scalds and damage to humidifier,
never put hot water in humidifier.
Step 1
To make cleaning easier, the humidifier base should be empty and completely
dried out. To accomplish this, use the following method:
a. Allow the humidifier to run until the REFILL message “F” illuminates and
the automatic shutoff has stopped the humidifier fan.
b. Unplug humidifier.
Step 2
a. Remove humidifier parts. See “Replacement and Care of Filter” page 10.
b.
NOTE:
There may be a little water still in the base. Carefully dump the
water out or remove with a sponge.
WARNING:
To reduce the risk
of shock, always unplug
humidifier before cleaning or
servicing. If humidifier is not
unplugged, fan could start after
housing is removed.
