Page
6
of
10
B.
Regular Wi-Fi Setup
This method permits “roaming” amongst multiple Access Points
Press the MENU button, then 7 (to go to settings)
Press 1 (to go to Wi-Fi setting)
Press 1 (for Profile)
Press the MENU button then press OK (for Add profile)
Enter a Profile name (such as Office)
[other profiles can be added at a later time, for other locations (such as home)]
Using the Navigation Ring (buttons around the OK button)
move UP (button above OK) or DOWN (button below OK)
Press the DOWN key to enter the SSID of the Access Point
Press the DOWN key to change the wireless Authentication
If WAP requires Authentication,
Use the RIGHT key, to change the wireless Authentication protocol
Then use the UP/DOWN keys to complete the needed wireless authentication credentials
(notice that the * button toggles between lower case, upper case, symbols, numbers)
Then press the OK button (unless you need to assign an
Optional
static IP address)
Optional:
If you need to adjust the IP Setting from DHCP to STATIC;
Press the DOWN key (ONLY, if you have entered a Password key)
Use the LEFT (button to the left of OK) or RIGHT (button to the right of OK)
to select which IP setting (DHCP or STATIC)
then use the UP/DOWN and complete the needed IP Address information
Do not press OK, until all of the Static IP Address fields (IP Address, Subnet Mask, Gateway)
is completed…
Once the Profile is saved and listed on the screen, you will need to select it and press OK, which will then
make it connect.
If the
connection is successful to the WAP
, you will see a message:
“
Not registered. Please check the account info
.”
This is an indication that you should proceed to Part 3 to enter the handset authentication information.
