Mohawk RJ-50-AH Series, Installation, Operation, Maintenance, Parts

Page: 10 / 34

MOHAWK MODEL RJ-50-AH-SERIES
5
INSTALLATION INSTRUCTIONS
IMPORTANT
READ THIS MANUAL IN ITS ENTIRETY. BE FAMILIAR WITH PART NAMES AND HAVE A GOOD UNDERSTANDING
OF HOW THIS UNIT IS TO BE ASSEMBLED AND OF HOW INDIVIDUAL
PARTS OPERATE, BEFORE ASSEMBLING THE UNIT.
REFER TO ANSI/ALI ALIS, SAFETY REQUIREMENTS FOR INSTALLATION AND SERVICE OF AUTOMOTIVE LIFTS.
INSTALLATION OF BEAM
THIS JACKING BEAM IS FOR USE ONLY ON MOHAWK
PARALLELOGRAM or TR-SERIES LIFTS.
MOVE JACKING BEAM TO END OF TRACKS. INSERT THE
JACKING BEAM BETWEEN THE TRACKS WITH ROLLERS ON
TRACK RAILS.
NOTE
FOR PARALLELOGRAM LIFTS: THE MEASUREMENT BETWEEN
THE TRACKS AT THE FORE AND AFT END OF THE UNIT MUST BE
THE SAME (45” +1/4 / -0 ) IN ORDER FOR THE JACK TO ROLL
SMOOTHLY ALONG THE ENTIRE LENGTH OF THE TRACKS.
FOR TR-SERIES (4-POST) LIFTS: THE MEASUREMENT BETWEEN
THE TRACKS AT THE FORE AND AFT END OF THE UNIT MUST BE
THE SAME (48” +1/4 / -0 ) IN ORDER FOR THE JACK TO ROLL
SMOOTHLY ALONG THE ENTIRE LENGTH OF THE TRACKS.
RAISE THE LIFT UNIT INSURING THAT THE WHEELS ON THE
JACKING BEAM ARE MAKING PROPER CONTACT WITH TRACK
RAILS
FINE ADJUSTMENTS TO THE WHEELS CAN BE MADE BY
ADJUSTING THE SCREWS AT THE UNDERSIDE OF EACH WHEEL
POSITION.
LASTLY, CONNECT AIR SUPPLY TO FITTING ON JACKING BEAM.
SUPPLY SHOULD BE 100-120 PSI, A MINIMUM OF 25 CFM, AND BE
DRY (USE OF A PNEUMATIC DRYER RECOMMENDED).
NOTE: AIR MUST BE CLEAN AND DRY, OR
WILL VOID THE WARRANTY.