Mohawk RJ-15, Installation, Operation, Maintenance, Parts

Page: 3 / 32

MOHAWK MODEL RJ-15 & RJ-25
ii
APPENDAGE:
Rev (9/28/2006)
LIFT ENVIRONMENT:
All standard lifts are designed for indoor usage in a normal garage type environment. Any concerns in
applications that expose the lift to additional environmental effects, such as paint booths, wash bays, outdoors,
high or low temperatures, etc. must be addressed to our engineering department, where provisions may be
made to the lift to accommodate the area of use. Our engineering department must be made aware in advance
of these conditions and any additional code requirements that must be met.
ACCESSORIES:
All accessories (i.e. Lifting Pads, Height Adapters, Wheel Adapters, Turf Adapters) supplied with this lift are
to be used on this lift only. Accessories from other lifts are not acceptable and could result in injury to the
user.
LOCKOUT/TAGOUT REQUIREMENTS:
The start switch provided with this unit must not be used as a primary disconnecting means. A separate
disconnecting means must be provided in accordance with all applicable codes. It is the responsibility of the
owner/user of this unit to provide a proper lockout/tagout device for this unit before or during installation in
conformance to ANSI Z244.1 and any local/state/national electrical codes and any OSHA regulations.
PROPER SELECTION OF POWER SUPPLY CORD:
Cord Size: 14/3
Cord Ampacity: 15 Amps minimum
Cord Wiring: Use Female NEMA Plug supplied with lift and wired as follows (See Diagram Below),
G: Ground (green)
Y: 120 VAC “Hot” to ground (Black)
Z: Neutral (white)
Face of Plug Represented: