INSTALLATION DATA SHEET
Remove 3 x M3 screws and the base plate from the body.
Pierce the cable grommet.
Insert supply/signal cable (maximum 7mm diameter) through the grommet,
pull back slightly (10mm), for the grommet to form a weatherproof seal.
Connect cable to terminal block.
Terminal Block
No Mode
1 Power
Input
+24v
dc
2 Return
0v
3
Signal - Sounder
+24v (high)
0v (low)
4
Signal - Green LED
+24v (high)
0v (low)
5
Signal - Amber LED
+24v (high)
0v (low)
6
Signal - Red LED
+24v (high)
0v (low)
Secure the supply/signal cable to the base with the cable grip.
Replace base plate, ensuring the gasket is in place and aligned to the ‘lead exit position’.
Secure with 3 x M3 screws.
General Installation Notes
• The DC supply must be fully rectified and smoothed. If the supply is used to power
other equipment, particulary inductive loads, additional suppression will be
required. Typical suppression units would be RS 219-2921 or RS 240-696.
• Installation must be carried out, in accordance with latest codes and regulations, by a
qualified electrician.
• Ensure power source is disconnected prior to installation or maintenance to avoid
electric shock.
• Do not handle internal electronic components whilst wiring up.
• Environmental exposure conditions during installation should be dry not
moist or wet conditions.
• The lens material of the beacon is VO rated Polycarbonate UV stable plastic. Do not
clean with petroleum based cleaners.
• The beacon is weatherproof to IP65 only when mounted with the lens uppermost
ie above the black base.
• Use 3 in total, 4mm diameter fixings (not supplied) to secure Beacon to its mounting.
• Avoid mounting the beacon where it will be subject to excessive vibration.
Gasket
Terminal Block
(No 1 to 6)
Position of Cable Grip
Cable Grommet
Lead Exit Position
Lens
Black Base
SIDE VIEW
OF BEACON
EXTERNAL
UNDERSIDE
VIEW OF BASE
INTERNAL
VIEW OF BASE
3 Holes x 4.5 DIA
on 88 pcd for
mounting
Piezo
Buzzers
11
o
Side knockout position
4 x 6.5 mm wide
11 mm
Lead exit
position -
5mm max
cable size
27.6
ø98mm
162mm
