Revision 6/F3501
©
Moffat Ltd, August 2006
E25 Convection Oven
-26-
Two Bolts
Two Screws
3) Uncrimp the retaining lugs of the window
spacer and remove the spacer and glass.
Retaining
Lugs
Figure 6.3.18
5) To replace, ensure that the two silicone
rubber seals are in place on the left hand
and right hand side of the door frame.
Clean the inside of the glass and refit it,
ensuring that the silicone rubber seals
cover the outer edges of the glass. Refit
the bottom trim, and fit the door to the
oven.
Figure 6.3.16
Two Screws
6.3.13 INNER GLASS (E25 / E25B)
1) Remove the outer glass (refer 6.3.12).
2) Undo two screws and remove the top trim
and handle assembly.
6.3.14 DOOR SEALS
1) Open oven door.
2) To remove, hold at their centre point and
pull forward until they unclip
3) Refit
new
seals.
Note: Fit top and bottom seals first, with
open side of seal facing
downwards. Fit side seals with
open side facing outwards.
Figure 6.3.17
4) To replace, ensure the silicone rubber seal
has not been displaced. Clean the glass
and refit it. Place the window spacer in
position and crimp the retaining lugs over
to hold the glass in place. Refit outer
glass as above.
Two Screws
6.3.15 DOOR HANDLE (E25 / E25B)
1) Remove the door (refer 6.3.12).
2) Undo two screws and remove the top trim
and handle assembly, taking care not to
dislodge the outer glass.
3) Undo two bolts securing handle to top
trim. Replace handle and reassemble in
reverse order.
6.3.16 DOOR HINGES
1) Remove outer glass (refer 6.3.12).
2) Undo two screws securing hinge assembly
to oven door.
Figure 6.3.19
3) Withdraw hinge assembly and replace.
Reassemble in reverse order.
Figure 6.3.20