组装管组件：
1. 拆下滑座。
2. 安装下墙座。
3. 重新套回滑座。
4. 上弯管套入上墙座。
5. 下直管组件旋入上墙座。
6. 锁紧紧定螺钉，调整上、下墙座的方向使其保持一致。
3
安装固定座：
Assemble the tubes
：
2
1
1. 如图示，标记并在墙壁上钻2个安装孔，深度为35mm。
2. 在安装孔内分别打入膨胀管，然后用自攻螺钉分别将上下固定
座固定在墙上，拧紧螺钉。
Install the fixing ring
：
1. As left figure, mark the location of drilling on the wall.Drill two
Ф6mm holes in the wall. The depth of the holes should be 35mm.
2. Insert the screw chassis into the holes, then locate the fixing
rings onto the wall with the Self-tapping screws. Tighten the screw
on the wall.
1. Take out the bracket.
2. Assemble the below cradle.
3. Put the bracket back to the straight tube.
4. Insert the upper tube into the upper cradle.
5. Screw the lower straight tube into the upper cradle.
6. Lock tight the setting screws, then adjust the direction of upper
and lower cradle to make them consistent.
Recommended 1000-1200mm
2-Φ6mm
孔深
Depth
:35mm
7
50mm
建议1000-1200mm
①
②
③
④
⑤
⑥
