Handle Insert Installation
1.
Be sure O-ring is in place on insert as shown.
2.
Screw insert into handle hub.
Faucet Installation
1.
Be sure basin is clean and dry. Place a 3/8" bead of
plumber's putty (not supplied) on underside of deck
gasket. Place faucet supplies down through holes.
2.
From under the sink, place the mounting nut/washers on
the faucet supplies, large side up. Thread on mounting
nut/washers by hand. Check faucet position. Align and
match escutcheon and escutcheon gasket together.
Make final tightening of the mounting nut/washers by
hand.
Disassembly
CAUTION: Turn OFF BOTH water supplies and open
BOTH faucet handles to relieve water pressure. This will
insure that COMPLETE water shut-off has been accom-
plished.
These instructions apply to both the hot and
cold sides. Parts and procedures are the
same for each side.
1.
Pry off the plug button using a thin bladed
instrument.
2.
Use a screwdriver and remove the handle screw.
3.
Pull handle hub up and off.
4.
Unscrew the cartridge nut. Use a wrench.
5.
Using pliers, pull cartridge straight up by the
cartridge stem.
MT125A
Flushing Instructions
1.
After installing and connecting your new faucet, turn on the water and let run for 15 seconds on both hot and cold setting.
2.
Turn off the water. Unscrew aerator from end of spout and clean the cone screen of any trapped debris.
3.
Replace the aerator.
Plug Button
Handle Hub
Handle
Insert
➤
➤
➤
Plug Button
Handle Screw
Handle Hub
Handle
Insert
Cartridge Nut
High Arc
Spout
Tea Kettle
Spout
Mounting
Hardware
Mounting Nut/Washer
Tailpiece Nut
Cartridge Stem
➤
➤
➤
➤
➤
➤
➤
➤
➤
➤
