Device Description Embedded HMI-PLC XV-23x-57
Hardware
Mounting instructions
9.2 S
TANDARD FRONT
1. Insert the supplied sealing strip in the groove (see figure) of the front plate. Cut the strip to a
suitable length so that the joint is tight.
2. Push the device from the front into the cutout of the front panel.
3. Fasten the rear of the device at the two corners on the top and bottom with at least 4 of the fixing
brackets provided (maximum torque 0.15
Nm).
The 4 additional fixing brackets are required for mounting to IP65 or in the Ex Zone 22.
These brackets are positioned in the middle of each side.
Groove for seal
Holes for fixing brackets
(central for IP65 mounting)
22
12/05 AWB2776-1581GB
© by Moeller GmbH
