MODSTER SPORT CUB S2, User Manual

Page: 21 / 24

F
User Manual MODSTER Super Cub S2
www.modster.at 21
The Sport Cub 500 comes with one-key return function, which enable the plane to return by the
opposite direction that the plane takes off.
Follow below steps to activate the function.
1. Place your plane heading to the take-off direction.
2. Do NOT unlock the throttle, press the activation button and hold for several seconds until you
hear a "beep" sound, the rudder surface will respond, meaning the one-key return function is now
activated.
NOTICE: Every time when you power on the plane, it requires to activate the one-key return
function.
To use this function during flight, press the one-key return switch button,the plane will turn around
automatically, back to the opposite direction where it takes off.
To quit, just press again the switch button, or control
any servo stick(rudder/elevator), the plane will back to
your control immediately.No matter you flies the plane
under manual control or gyro assist mode, when you
turn on the one-key return function, the plane will
enter gyro assist mode automatically to help stable
flying back. When you quit this function, the plane will
back to the what the control mode it was.
CAUTION: This function is bound to the receiver,
instead of to the transmitter, which means the plane will return ONLY to the opposite direction
that the plane takes off. It also means when the plane returns and passes the position where you
activated the function, the one-key return function will NOT return the plane back to the take-off
position.
Channels Reverse
WARNING: Normally this function is not necessary to be operated. Only operate the
below steps when you understand completely of the channel reverse function.
1.Turn the throttle stick to min position.
2.Power on the Transmitter and the receiver.
3.Do NOT unlock the throttle.
4.Turn the channel stick to max position of any side and hold for several seconds.
5. When you hear a “beep” sound, it means the channel is reversed.
One-key Return Instruction
One-key Return
Activation
One-key Return
Switch
Gyro System Calibration
1.Turn the throttle stick to min position.
2.Power on the transmitter and the receiver.
3.Do NOT unlock the throttle.
4.Keep the sticks as above picture for several seconds.
5.When you hear a “beep” sound, it means the gyro
system is calibrated based on the horizontal level you are
keeping it.