Modern Forms Aviator 5, Installation Instructions Manual

Page: 18 / 36

FR-W1811
Aviator Instructions 18
7. Finishing the Installation
1. Secure all wire connections with supplied wire ties to assist in
canopy installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the canopy up to hanger bracket and place the key hole on
the canopy over the screw on the hanger bracket. Turn canopy
until it locks in place at the narrow section of the key holes (Fig. 7).
4. Align the circular hole on canopy with the remaining hole on the
hanger bracket. Secure by tightening the one screw previously
loosened and the one previously removed.
5. Adjust the canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING: Make sure tab at bottom of hanger bracket is properly
seated in groove of hanger ball before attaching canopy to bracket.
Failure to properly seat tab in groove could cause damage to
electrical wiring.
1. Attach the blades to the blade support plate with included head
screws (21) (Fig. 5).
2. Flip the fan blades and support plate over.
3. Attach the blade collector ring to the opposite side of the blade
support plate. Use the included Truss Head Screws (11)
(Fig. 5A).
4. Attach the blade set (with blade support plate and blade collect
ring) to the fan housing. Use the included S Phil/Slotted Screws
(6) (Fig. 5A).
1. Install the decorative lower cap adapter as shown (Fig. 6).
2. Tightly twist the decorative lower cap onto the motor assembly
(Fig. 6).
5. Attaching the Fan Blades
6. Attaching Decorative Lower Cap